• Reliable, rugged, durable design
• Field-proven in thousands of applications worldwide
• Four-stroke-cycle diesel engine combines consistent performance and excellent fuel economy with minimum weight

• Superior motor starting capability minimizes need for oversizing alternator
• Designed to match performance and output characteristics of Cat diesel engines
• Robust Class H insulation

• User-friendly interface and navigation
• Scalable system to meet a wide range of installation requirement
• Expansion modules and site-specific programming for specific customer requirements
• Image may not be a representative of actual product

• Designed to operate in standard ambient temperatures up to 55°C (131°F)
• Contact your Cat Dealer for specific ambient and altitude capabilities

Cat dealers provide extensive post-sale support including maintenance and repair agreements. Cat dealers have over 1,800 dealer branch stores operating in 200 countries. The Caterpillar S•O•S℠ program cost effectively detects internal engine component condition, even the presence of unwanted fluids and combustion by-products

• Components used in the generator set are selected based on seamless design integration to provide the optimum performance
• The generator set is fully assembled at a Caterpillar facility following our quality guidelines
• Each generator set package is tested before leaving the Caterpillar facility
• Cat product support, including dealer service, parts and warranty covers the entire Cat power system

• Cat dealers have over 1,800 dealer branch stores operating in 200 countries
• Your local Cat dealer provides extensive post-sale support, including maintenance and repair agreements

• Air cleaner

• Package mounted radiator

• Fan drive, battery charging alternator drive
• Radiator and cooling fan with guards
• Coolant drain line with valve
• Caterpillar extended life coolant

• Exhaust flange outlet

• GCCP 1.3

• Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose

• Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank

• Secondary fuel filters
• Primary fuel filter with integral water separator
• Fuel priming pump

• Segregated low voltage (AC/DC) wiring panel
• Voltage regulator (single phase sensing)
• Matched to the performance and output characteristics of Cat engines
• 12 Leads
• Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
• Circuit breaker, IEC, 3 pole, mounted in tower panel
• Tower panel, IP22, bottom cable entry
• IP23 Protection

• Mechanical and electrical governing system - model dependent

• Lubricating oil
• Oil drain line with valve

• Busbar

• Captive linear vibration isolators between base and engine-generator
• Includes lifting provision and drag points
• Termination points for coolant and lube oil drain lines

• Rubber vibration isolators

• 24V battery with rack and cables

• Paint - Caterpillar yellow except rails and radiators gloss black
• Engine and alternator pre-paint, Caterpillar yellow

• 24 volt starting motor
• Batteries

• Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)
• Oversize and premium generators
• Anti-condensation heater

• 3 phase sensing
• Permanent magnet excitation (PMG)
• R Frame auxilliary winding
• Quadrature droop kit
• LC Frame alternator with coastal insulation protection

• Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A

• Circuit breakers, IEC compliant
• Circuit breakers, UL listed

• GCCP 1.3
• Load share module
• Digital I/O module
• Remote monitoring software
• Local & remote annunciator modules

• Coolant heater
• Low coolant level shutdown
• Low coolant temperature alarm

• Earth fault (2 wire only)
• GCCP 1.3
• Volt free contacts
• Emergency stop with key
• Battery charger
• Panel mounted audible alarm
• Control panel heater
• Speed adjust potentiometer
• Voltage adjust potentiometer
• Earth leakage (2 wire only)
• Overload shutdown via breaker

• Jacket water heater
• Charging alternator
• Heavy duty starting system
• Battery chargers
• Oversize batteries

• Sound attenuated Level 2 enclosure
• Sound attenuated Level 1 (galv)
• Rental pack - CAE rental option only

• Upgrade to STD set for CE

• Compact skidbase for open set
• Low fuel level alarm
• Low fuel level shutdown
• Bunded fuel tank
• Open set narrow tankbase
• Skidbase for CALG enclosure sets
• High fuel level alarm

• Single or dual wall sub-base fuel tanks
• EU Certificate of Conformance (CE)
• CSA Certification
• Single or dual wall integral fuel tanks
• Automatic transfer switches (ATS)
• Narrow, wide or skid base
• UL 2200 package
• Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
• Sound attenuated, weather protective or high ambient weather protective enclosure
• EEC Declaration of Conformity
• Integral & sub-base fuel tanks

• Certification for CIS

• Battery removal
• Electronic governor
• Industrial silencer
• Silencer installation kit
• External single point lift - enclosure

• PGS Test report @ 1.0 power factor
• PGS Test report @ 0.8 power factor

• Packing case - compact set
• Stone guards/rad trans flange
• Packing case - canopied set