CN1566 Electric Motor

Request Info

SPECS SUMMARY

Mounting DesignationF1 or F2
Locked Rotor Amps500% Code E
Full Load Current202 Amps
Rated Torque6625 lb/ft (8982 N·m)
Get power built for your most demanding gas compression applications. Every Cat® electric motor is tested at each stage of production to make sure it performs reliably under load and according to your process requirements. High operating efficiency and low operating costs come with low noise levels and no emissions. Cat electric motors for gas compression are backed by the worldwide network of Cat dealers ready to support your operation with technical support, service, parts, and warranty.

Specifications

Mounting DesignationF1 or F2
Locked Rotor Amps500% Code E
Full Load Current202 Amps
Rated Torque6625 lb/ft (8982 N·m)
Maximum Altitude - Before Derate3000 ft (1000 m)
Maximum Ambient Temperature104 °F (40 °C)
Temperature RiseClass B at rated load
DutyContinuous
Enclosure Type/Method of CoolingWP-II
Service Factor1.15 SF (1.0 VFD)
No Load Current67 Amps
Number of Poles6 poles (6 poles)
Locked Rotor Torque60%
Connection of Stator WindingStar
StandardsNEMA MG1
Shaft5.1 in (130 mm)
Full Load Speed1189 r/min (1189 r/min)
Type of EX-ProtectionClass 1 Division 2 Group A,B,C,D T3 (NEC or CEC)
Electric Motor TypeSquirrel Cage Induction Motor
Voltage/Frequency4000V ± 10%/60 Hz
InsulationClass F

Standard Equipment

  • Bearing RTDs for temperature monitoring
  • Insulated non-drive end bearings to reduce bearing currents
  • Anti-friction on 1500 hp (optional)
  • Designed for minimal vibration
  • Dynamic balancing at full operational speed
  • Fabricated copper squirrel cages
  • Oversized, forged, keyless shaft
  • AISI 4140/DIN42CrMo4 shaft
  • Radial air ducts ensure uniform and efficient cooling
  • Vacuum pressure impregnated with specially formulated epoxy resin
  • 2X RTDS per Phase
  • Space heater
  • Welded and machined stator core retains its rigidity throughout motor life to ensure a sealed and homogeneous insulation system that results in high dielectric strength, excellent heat transfer and the elimination of hazardous internal partial discharges